Trademarks: “ICC,” the International Code Council logo and “Accessible and Usable Buildings and Facilities (ICC/ANSI Al )” are trademarks of the. The edition of ANSI Standard A presented the first criteria for requirements and identify changes from the edition. . ICC/ANSI A Major changes/additions from ICC ANSI A – found in the edition of A 1. ICC ANSI. A – Section. ICC ANSI A –
|Published (Last):||8 October 2016|
|PDF File Size:||14.52 Mb|
|ePub File Size:||15.88 Mb|
|Price:||Free* [*Free Regsitration Required]|
Where handrails ansu provided on the ramp run, the clear width shall be measured between the handrails. Consensus is established when in the judgement of the ANSI Board of Standards Review, substantial agreement has been reached by directly and materially affected interests.
ANSI A117.1 (2003): Accessible and Usable Buildings and Facilities
Landings shall com- ply with Section Gripping surfaces shall be continuous, without interruption 11 newel posts, other construction elements, or obstructions. Operable parts shall be operable with one hand and shall not require tight grasping, pinching, or twisting of the wrist. Communication Elements and Features the telephone shall be 10 inches mm maximum.
Wheelchair accessible public telephones shall comply with Section icv The down scan button shall sequentially select floors below the current floor. The audio output from an internal speaker shall be at 75 dBA minimum at 18 inches mm with a maxi- mum distortion of 10 percent.
State Building Code – ICC/ANSI A Code Interpretations
Accessible Routes General Function keys shall contrast visually from background surfaces. The high forward reach shall be 48 inches mm maximum where the reach depth is 20 inches mm maximum. Section of this standard provides criteria for Type B units.
Subscription pricing is determined by: Describes a site, building, facility, or portion thereof that complies with this standard. Swinging doors shall have maneuvering clearances comply- ing with Table Destination-ori- ented elevators shall provide car identification in tactile characters complying with Section Visible signal fix- tures shall be centered at 72 inches mm minimum above the floor.
Building Blocks General Tactile characters shall be 2 inches 51 mm mini- mum in height. Water closets and toilet compart- ments primarily for children’s use shall be permit- ted to comply with Section Requests for interpretations should be addressed to the secretariat or sponsor whose name appears on the title page of this standard.
Truncated domes shall have a base diameter of 0. Signs annsi van parking spaces shall contain the designation “van accessible.
Table of Contents | ICC/ANSI A – | ICC premiumACCESS
In standard roll-in showers with seats, the controls and hand shower shall be located on the back wall, no more than 27 inches mm maximum from the end wall behind the seat.
This standard is also available to be included in Standards Subscriptions. Each arm of the T shall be clear of obstructions 12 inches mm minimum in each direction, and the base shall be clear of obstructions 24 inches mm minimum. The out- let of the dispenser shall be 14 inches mm minimum and 19 inches mm maximum above the floor.
Plumbing Elements and Facilities General Handrails required by Section Inside dimensions of elevator cars shall comply with Table Elevator doors shall be horizontal sliding type.
Swing-up grab bars shall comply with Sections Icd shall be V 2 inch 13 mm minimum in height. Floor surface within the maneuvering clearances shall have a slope not steeper than 1: Communication Elements and Features phone handset. Accessible routes shall comply with Section A technology used to enter a car call by means of an up or xnsi floor selection button.
Braille shall be 48 inches 1 mm minimum and 60 ansu 1 mm maximum above the floor, measured to the baseline of the braille cells.